Re: Super C repower question

Posted by Chris on August 12, 2004 at 16:06:40 from (64.12.116.14):

In Reply to: Re: Super C repower question posted by Haas on August 08, 2004 at 18:30:20:

Thanks Haas for the info. There is a guy here that direct bolted that motor into a B. However, on the combine motor there is a notch for the starter in the bell housing. I was wanting to keep the stock appearance for a few antique pulls--need to teach those green and yellow boys a lesson or two. I was mainly concerned about the crank and rods fitting while using a high dome overbore kit for the pistons. Possibly even use the cam out of the combine. I am using the tractor with a 6 ft finish mower and it doesn't perform quite up to my expectations. Can never have enough hp! Thanks again.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]