|
Farmall & IHC Tractors Discussion Board |
Generator won't polarize properly? - ammeter alway
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ted on July 26, 2004 at 12:28:30 from (208.1.81.16):
When I start my farmall A, the ammeter always shows -10 amp (discharge) a few seconds after starting (once the points close on the Voltage regulator). I have replaced all the wiring, torn the generator down to make sure that all the contacts are good, tested the generator unhooked to the Voltage Regulator (it showed 10 v) and replaced the voltage regulator. I've tried polarizing (by momentarily shorting out the A terminal with the BAT terminal) several times. I can't get this thing figured out and to charge positive. I have installed an 8v battery. could this be part of the problem? OR the generator is off of a super C. Were they negative ground by any chance? I'm stuck and getting frustrated. - thanks
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
