|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Rod bolts
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by F-Dean on July 08, 2004 at 19:53:19 from (12.74.46.112):
In Reply to: Re: Re: Rod bolts posted by Eric on July 07, 2004 at 19:04:53:
Eric,
Both. On the head bolts, I tighten them gradually and in a pattern. I tighten everything snug then tighten everything to 70 Ft-Lbs in a pattern starting with the center nut. Then I work in a circular/spiral pattern towards the ends. When everything is tightened to 70 ft-lbs, I tighten all the nuts to 80 ft-lbs in this same pattern and then everything to 90 ft- lbs.
On the rods, I use the same stepwise pattern but with only two bolts, it is simplier. In other words, Tighten one to 70 Ft-Lbs then the other. Then 80 ft-lbs and finally 90 Ft-Lbs.
Hope this helps.
Dean
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
When Push Comes to Shove - by Dave Patterson. When I was a �kid� (still am to a deree) about two I guess, my parents couldn�t find me one day. They were horrified (we lived by the railroad), my mother thought the worst: "He�s been run over by a train, he�s gone forever!" Where did they find me? Perched up on the seat of the tractor. I�d probably plowed about 3000 acres (in my head anyway) by the time they found me. This is where my love for tractors started and has only gotten worse in my tender 50 yrs on this �green planet�. I�m par
... [Read Article]
Latest Ad:
For sale Farmall super A tractor is complete and has just been setting for awhile,it was running when pulled out of the barn,shouldn’t take to much to get it going asking 1100.00
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
