|
Farmall & IHC Tractors Discussion Board |
Re: Re: H distributor plate marks - possibly for D
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Dave in CT on July 08, 2004 at 18:40:19 from (204.60.63.181):
In Reply to: Re: H distributor plate marks - possibly for Dave posted by Dave W V on July 08, 2004 at 18:18:10:
Well, everything looks pretty close to the exploded view in the I&T manual but I suppose the cam could be backwards. I'm hoping to have a look this weekend at a local gas-only H's distributor. It sounds like filing or drilling out a slot to allow for 40 degrees max advance is a workable solution. The I&T manual says 20 dist degrees at 800 dist RPM so I'm doubling and that matches what the H Owner's manual says is max advance. Now if I can find a distributor shaft to make a template from, elongating the advance slot shouldn't be too hard. Thanks for all your input.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Hydraulics - Cylinder Anatomy - by Curtis von Fange. Let�s make one more addition to our series on hydraulics. I�ve noticed a few questions in the comment section that could pertain to hydraulic cylinders so I thought we could take a short look at this real workhorse of the circuit. Cylinders are the reason for the hydraulic circuit. They take the fluid power delivered from the pump and magically change it into mechanical power. There are many types of cylinders that one might run across on a farm scenario. Each one could take a chapter in
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
