|
Farmall & IHC Tractors Discussion Board |
Re: International 584 with front loader
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by JB on July 07, 2004 at 18:58:45 from (24.157.143.220):
In Reply to: International 584 with front loader posted by ben UK on July 07, 2004 at 10:51:50:
Hi, in Canada a 584 with cab & 2250 loader would be about $17,000 CDN. see URL. My brother has 495 (one size smaller than 584) with 2250 Quick Attach loader on it. The 2250 is a great loader but it is to heavy for front end on 495. I wanted him to put the loader on his 684 but he insisted on the 495 and has sheared off hub bolts, split the channel iron on the front axle etc. But I believe the 584 has the same front axle as 684 which is much heavier. So you should be good. These are great tractor except for the parking brake problems. Always be sure to use only IH Hytran fluid in hydraulics/transmission. If it has a T/A when the T/A is in High position this is direct drive and LO position is in T/A drive. A quick check of T/A is to put tractor on a steep slope with front pointing down the slope. With T/A in High position and gear shift in 4th High range, turn the engine off and engage the clutch and don't touch the brakes the tractor should not roll forward. If it does roll forward it should turn the engine over. Repeat again with T/A in LO position. Good luck JB
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|