Re: Re: Re: Workin on the 300 some more

Posted by tractor dan on July 05, 2004 at 13:20:03 from (64.12.117.22):

In Reply to: Re: Re: Workin on the 300 some more posted by Kelly C on July 05, 2004 at 12:54:18:

i have made two so far one for a ford 8n and the last one i made was this spring for a ford 8600 this one was a little easier because i allready had the new liners i have not yet pulled liners on a wet sleeve engine only dry i would think wet sleeve would be much easier
had to make puller a bit heavier for the 8600 than 8n one
its takes a lot of time to make the way i did but used tools handy to me torch, grinder, then file drilled and taped center with 3/4 inch
well good luck

Follow Ups:

Post a Followup Name: E-Mail: Subject: Re: Re: Re: Re: Workin on the 300 some more Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]