Farmall & IHC Tractors Discussion Board |
Re: I300I350 HP vsFI300F350HP
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by CNKS on June 27, 2004 at 14:47:24 from (207.178.96.211):
In Reply to: I300I350 HP vsFI300F350HP posted by Harold H on June 26, 2004 at 19:47:22:
Harold, I responded to the original post and gave the HP differences, someone answered me and said essentially the same thing you did about the rpm. It would make sense that lower rpm equates to longer engine life. However, I've always thought that IH built the 300 to compete with the Ford and Ferguson, which were always "utilities" (at least until they began to build higher profile tractors, don't remember when that began), and that many farmers used them for tillage. I grew up in vegetable country, and a Ford or Ferguson pulling a plow was common. I left the farm to go to college about that time, so I did not see many 300U's. I have had no personal experience with the 300, so I could be wrong.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|