|
Farmall & IHC Tractors Discussion Board |
Farmall B sleeve question
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ken on June 24, 2004 at 22:50:36 from (152.163.253.103):
I have an early 50s B and the front piston was stuck, water in it of course, it didnt take much however to loosen it up. I took the piston out and cleaned up the cyl. and noticed small rust pits about 2 inch down from the top of the block into the cyl. wall. Question is this, is this something that can be honed out and if so can I still use the stock piston and rings? Its the front cyl. and all the others look great so Im really not wanting to put a complete set in. If I cant hone it all out is my only option another sleeve and can I purchase just one? Will minor pitting cause me some problems down the road if I hone it good and go with it?
Thanks in advance for any help.
Ken
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
