|
Farmall & IHC Tractors Discussion Board |
Re: Re: farmall H pto shaft
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Eris Ripley on June 23, 2004 at 19:34:18 from (152.163.253.103):
In Reply to: Re: farmall H pto shaft posted by riverbend on June 23, 2004 at 14:30:35:
so it is easier to see what broke that way but I can already see what brke through where the pto comes out it is right at the end of the shaft that goes from the tranny to the rear end so I can see it where it broke but how do I get that shaft out to measure it up and replace it?
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Talk of the Town: Miracle Formula for a Stuck Engine - by Edited by Kim Pratt. Another great discussion from the Tractor Talk Discussion Forum. The discussion started out with the following post: I have a stuck 4 cylinder engine. Two pistons right at the top, other two down. From underneath everything looks good. Up top looks bad. Thanks in advance."
... [Read Article]
Latest Ad:
Looking for a minneapolis moline zts
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|