Re: Re: Putting mains and rod bearings in H

Posted by Bob M on June 21, 2004 at 07:44:27 from (165.170.128.65):

In Reply to: Re: Putting mains and rod bearings in H posted by Mark in Mi on June 21, 2004 at 06:45:53:

Thanks Mark & Dave! I�m ready install new bearings in my SH (soon as the brown truck delivers �em...) and until now have been uncertain of the R&R process. Your advice helps a bunch!

Note: On my SH each rod cap is clearly stamped with it�s respective cylinder number. Did not however see any ID marks on the main caps. So before I took the mains down I prick-punched each cap with for position and orientation in order to return them same as before. And yes - I'm figuring to check the new bearing clearances with Plastigage before buttoning everything up for good...

Follow Ups:

Post a Followup Name: E-Mail: Subject: Re: Re: Re: Putting mains and rod bearings in H Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]