Farmall & IHC Tractors Discussion Board |
Re: The M stalled again
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jed on June 14, 2004 at 11:58:05 from (66.212.143.210):
In Reply to: The M stalled again posted by William Ransom on June 14, 2004 at 11:24:05:
I agree with Rustyfarmall. Clean the tank. I don't know where some guys get the idea that gasoline and fuel doesn't age, but it does. When it does it causes major deposit formation problems. All of the junk, particulates and such, in the tank has to go by way of the bowl and then the carb. I am currently fighting with the same problem on an H. Being a little lazy I always look for a quick fix, but after flushing the tank several times, all I have done is plug jets in the carb. If you choke it it will run, but it has no power. Also I still notice it smoking sometimes, but when it runs okay it doesn't smoke. I am convinced that there are heavy deposits still on the tank walls.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|