Farmall & IHC Tractors Discussion Board |
Antifreeze spots on edge of head
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by waynekittler on June 05, 2004 at 12:38:52 from (24.194.176.20):
Did the tappets on my IH 200 cu inch gas Monday. Went to put the valve cover gasket on Friday and there were three one/quarter inch buttons of anti-freeze in a line on the lip where the gasket sits. Does not seem to be a visible crack through the head at this spot. Did have some sludge on the inside of the cover on the tractor seat end of the valve cover. Been 14 years since I took the cover off. Can I run the tractor without causing water damage to the engine? Water level in the rediator has been prety good.
Follow Ups:
Home
| Forums
Today's Featured Article -
History of the Nuffield Tractor - by Anthony West. The Nuffield tractor story started in early 1945. The British government still reeling from the effects of the war on the economy, approached the Nuffield organization to see if they would design and build an "ALL NEW" British built wheeled tractor, suitable for both British and world farming.
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|