Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Farmall Front Axle
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul in Mich on May 29, 2004 at 14:52:48 from (68.188.227.110):
In Reply to: Re: Re: Farmall Front Axle posted by Rusty Berg on May 29, 2004 at 14:27:22:
Rusty, The center line of your front axle is under the steering gear box, which is not center of the engine and drive train. The rear wheel adjustment is relative to that imaginary line from front to back. IH made it easy tho, in that when adjusting the width of the rear wheels, they will always be the same distance to the center line if they are mounted on the dishes exactly the same way both right and left. The dishes are the wheel parts that bolt onto the rims. The right hand dish ( looking from back to front) is cast steel and is thicker than the left hand dish which is pressed steel. The cast dish is heavier to compensate for the fact that the engine and drive train is offset from the center line. this gives the tractor the proper balance. The rear wheels will actually adjust further in than the front. With the rears adjusted all the way in, the front wheels will track along the outside edge of the rear track. you can make adjustments in 2 inch increments and therefore make 2 or 3 adjustments outward with the rears before you would lose tracking path of the fronts. Generally, you like the fronts to track either center to center of the rear wheels, or have the fronts set along the inside edge of the rear wheel track. I hope I'm not confusing you more than helping you. Good luck, and if you need further explaination, don't hesitate to post back.
Follow Ups:
Home
| Forums
Today's Featured Article -
Magic Moments - by Tyler J. Woods. Magic moments don’t just happen. You have to help them along. This morning, I got up early. It is my day off from my regular workweek and I had a lot of things to do. It’s fall, and with winter coming on, there is a lot of work to do before weather closes in.
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|