|
Farmall & IHC Tractors Discussion Board |
Re: SA cultivator set up
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Jim Becker on May 21, 2004 at 08:47:42 from (4.26.211.8):
In Reply to: SA cultivator set up posted by mikeinWA on May 20, 2004 at 15:12:42:
The answer depends a little on your tire size. Unless you have unusually narrow tires, you will need more than a foot between the rows where the wheels will run. Narrowest setting for the Super A is 40". But with typical tire sizes, 44" is as narrow as you can set them. For what you are doing, I would suggest the narrowest available setting for your tire size. Assuming it is 44", you can set your planter up for 3 rows at 12". But you will need to leave about an 18" space before the next 3 rows. Otherwise, the tractor tires will be running too close (if not directly over) the outside row from the previous pass. I suggest you make some sketches of your row and wheel spacings to work this out before you try it with the tractor. The Owner's Manuals for the vegetable cultivators have some drawings that would help but I didn't see one that matched your spacings. When you drop off the outer planting units and do a single row, a 3 foot spacing will work fine. All these details go bad if you have exceptionally large tires. Then a little more row width will be required. For cultivating the small vagetables, I think a tool bar set-up would be preferable. But when your corn starts to get tall, the tool bar will hurt your crop clearance. You may need to make some compromises on the cultivator set-up. Follow the link if you want to take a look at my Cub with a vegetable cultivator installed. It is actually a Super A cultivator (wider than Cub unit). It is set up for 4 rows on 24" spacing, with knife weeders next to the rows and ducksfoots to catch the space between. They move very little soil and can be used close to small plants.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|