|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: 16 front rims for 130, 230 etc.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Paul in Mich on May 16, 2004 at 20:19:37 from (68.188.227.110):
In Reply to: Re: Re: 16 front rims for 130, 230 etc. posted by Hugh MacKay on May 16, 2004 at 19:40:15:
Hugh, Welding 3 dogs on each rim shouldnt be all that hard, you can use some angle iron for that matter, then make spacers to go between the dogs and the hub casting. The old style were just that except that the spacers were an integral part of the angle piece. As long as you have your bolt hole pattern right so that your hub is centered right, I think you have the problem about whipped. You're right, we didnt seem to inspire your brother to spend much time here on YT. Oh well, we cant convert everyone....
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Major Problems - by Anthony West. Following the aquisition of the two Fordsons to my collection I found that I was struggling to move them about. I had considered the possibility of driving the "F" to and from shows but anything other than local rallies was totaly impractical due to its sedate pace. I had also considered buying a landrover and trailer, but the price of a
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
