|
Farmall & IHC Tractors Discussion Board |
560 Diesel Sleeve Installation
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by bryan on May 16, 2004 at 05:16:04 from (66.173.39.236):
I am in the procees of overhauling my 560D and purchased the sleeve kit .005 over standard. My question is, If the sleeves are .005 larger that means I have to make the counter bore larger to recieve the new sleeves. Also I have been told to run a rigid hone down the new sleeve to get all the inperfections out of the sleeves. Are they not already honed and ready for the installation of the pistons? What is a good way to to install the sleeves back into the block.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Major Problems - by Anthony West. Following the aquisition of the two Fordsons to my collection I found that I was struggling to move them about. I had considered the possibility of driving the "F" to and from shows but anything other than local rallies was totaly impractical due to its sedate pace. I had also considered buying a landrover and trailer, but the price of a
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
