Re: H Sleeves

Posted by Bob in SE Nebraska on May 06, 2004 at 10:44:13 from (162.40.71.183):

In Reply to: H Sleeves posted by DANO on May 06, 2004 at 10:33:52:

There is no gasket for the sleeves of the H. When I installed sleeves in my H, I ran a cylinder hone down the block just to clean it up some. I then cleaned the block very well, put a light coat of oil on the block cylinder walls and on the outside of the sleeves and pushed them into place. I did use a block across the top of the sleeves and drove them in carefully. I may have just gotten lucky but it went very well for me. Hope this helps.

Bob

Follow Ups:

Post a Followup Name: E-Mail: Subject: Re: Re: H Sleeves Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]