|
Farmall & IHC Tractors Discussion Board |
M Lambert brake tear down results
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by jamie on April 26, 2004 at 20:10:49 from (24.178.78.229):
Tore both sides down today. The one side that I had originally taken apart was in good shape overall, but the side I hadn't opened up yet was in bad shape. The actuator plates were rusted and the pads were wore down into the rivets on one pad. These pads are 6" 26 spline. There was no oil at all in either side. I took several pics that I'll upload as soon as I figure out how to do so. The side that was bad (right) also was odd. There was a machined groove about 1/4" from the outer edge of the splined hub and one pad/disc had no splines. Also, where the inner pad goes on the hub, the splines were wore down pretty badly. Are these hubs available? If so, how much do they run and do you simply remove the bolt on the inside of the hub to replace it? Again... the pics will help once I get them uploaded. Thanks guys. Also, both the cone shaped return springs were broken in a couple places so I'm not sure if its worth putting them back in or not. Couldn't you just make a similar sized spring work anyway? Are these available from IH/Case? Thanks a ton for any info. I'm also gonna upload all the info and pictures I get on these brakes to my website for anyone that ever has problems with them to refer to.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Old Abe is Still Making Hay - by Jeremy Sweeten. Things have changed a bit since my last article. I am now almost finished graduate school at Purdue University. I am still in Agronomy, but specializing in hay and forages. My wife has survived two years of marriage to a part-time farmer. The equipment line up has changed a bit too. The DC has retired to
... [Read Article]
Latest Ad:
2555 Mahindra Shuttle 4x4 heat,air,diesel,7ft Mahindra heavy duty bushhog 7ft snowblade bucket
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|