Re: Re: Re: Farmall H rod journal size

Posted by Jonathan Mirgon on April 25, 2004 at 19:47:52 from (205.208.129.121):

In Reply to: Re: Re: Farmall H rod journal size posted by Jim on April 25, 2004 at 17:19:41:

bearings are available in .001 and .002 oversize, I would put the original rod and cap on one of the journals, along with the bearings that came out and plastigauge them, I am just finishing up mine, when I checked the original bearings I had about .004 with the plastigauge, so I ordered the .002 bearings, thus putting my clearance between the .002 and .003 that is called for. Ideally the best thing to do is have the crank machined and start al over, But I too did not want to pull the motor in order to machine the crank, I was just replacing pistons liners and rings.

Follow Ups:

Post a Followup Name: E-Mail: Subject: Re: Re: Re: Re: Farmall H rod journal size Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]