Farmall & IHC Tractors Discussion Board |
Re: new farmall M and not sure what to do
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John A on April 10, 2004 at 04:48:18 from (208.24.233.2):
In Reply to: new farmall M and not sure what to do posted by sccwells on April 09, 2004 at 21:31:42:
sccwells, Judgeing by you opening statement, you havea running tractor. Since that is the case start with the small stuff. Compression test!, A good tune up...points,plugs,condencer, wires, distributor cap. Check the wireing harness, If butchered there are good places to get new ones. If the copression test are low, then a decision has to be made to do an overhaul, and that goes into a a new story, with problems, of its own. pack the front wheel bearins. Maybe new tires? Get the wear out of the seat assembly. New rubber bushings, shock absorber,etc. The front bolster may need to be reworked, if there is still excess play in the steering after adjusting. No matter the problem, that you run into on your tractor....There is a wealth of info here on this forum. Just ask, tell the symtoms and there is someone who can walk you through it...chapter & verse. Good Luck, John A.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|