Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Need help with set up 2pt fast hitch p
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ken K on April 05, 2004 at 21:39:18 from (67.200.32.57):
In Reply to: Re: Re: Need help with set up 2pt fast hitch plow. posted by Kelly C on April 05, 2004 at 20:15:06:
Hi Kelly I see your bottoms are painted with red paint! Have you taken the paint off the bottoms? Your will probably never get the bottoms to scour with all that paint on them. Get the bottoms as shinny as you can get them with sand paper and wire wheel on a drill etc. Then lift your colters up so they don't cut very deep, or take them off if don't have much trash, and drive fast to get a good "land polish". If you have some sandy soil, this will help you also. Once you get a good polish, and you are not using the plow, keep your plow bottoms painted with a special paint, see your local farm store, for keeping the moldboards from rusting. It looks like a thin black tar. I get mine in a gal. can at Farm & Fleet here in Illinois. Speed should not be a problem for you with that 400 and 2 bottom plow! Can't help you with adjustments for fast hitch plow. Good Luck!
Follow Ups:
Home
| Forums
Today's Featured Article -
An Old-Time Tractor Demonstration - by Kim Pratt. Sam was born in rural Kansas in 1926. His dad was a hard-working farmer and the children worked hard everyday to help ends meet. In the rural area he grew up in, the highlight of the week was Saturday when many people took a break from their work to go to town. It was on one such Saturday in the early 1940's when Sam was 16 years old that he ended up in Dennison, Kansas to watch a demonstration of a new tractor being put on by a local dealer. It was an Allis-Chalmers tractor dealership,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|