Farmall & IHC Tractors Discussion Board |
Farmall H Belly Pump
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Ryan George on March 24, 2004 at 20:57:02 from (69.88.204.207):
i pulled the belly pump to re route the return line from my live hydraulic pump directly into the belly pump. however, when i pulled the "pump" it turns out someone had already gotten rid of the pump and put a resevoir in it's place. there are no other pipe fitting on the resevoir than the breather tube outlet, live pump feed, and drain plug. i am considering drilling a hole in the plate that bolts on the side of the resevoir and welding a pipe fitting in the plate to return oil from a control valve. any comments or other suggestions are welcome. also, will returning the fluid to a lower spot on the resevoir eliminate my problem of oil coming out of the breather tube? ( oil used to be returned about an inch or two below the breather tube) Thanks!
Follow Ups:
Home
| Forums
Today's Featured Article -
Updatin The Charging System of Your Older Tractor - by Tyler Woods. Older tractors have externally regulated generators or externally regulated alternators, in some instances. That means there is one device that turns energy from the fan belt into electrical energy,
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|