|
Farmall & IHC Tractors Discussion Board |
Roosa-master fuel pump on 560
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by harley1983 on March 16, 2004 at 17:49:33 from (64.136.26.230):
Can anyone tell me about how to stop fuel leaking from the little governor block on the bottom of the fuel pump on a 560 D. My local IH dealer sent me an oval gasket to put between the block and the pump, and now it leaks worse than ever, but surely this is not supposed to be metal to metal is it? The block is held on by one 12 point bolt about 3/8 diameter and it has an o-ring around it, but where it is leaking is right next to that where the stub shaft with the ball on the end sticks down out of the fuel pump. Any help would be appreciated.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
