Farmall & IHC Tractors Discussion Board |
Re: What does this serial number tell you
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by TDK on March 10, 2004 at 19:54:25 from (64.12.97.12):
In Reply to: What does this serial number tell you posted by Kirk on March 08, 2004 at 18:31:16:
Dave ID is correct on the FF & S codes. The X is High Speed Low & Reverse.I believe the Y code means Hyd. power Supply w/ 14 g.p.m. pump. I'm not positive on this one. I took for granted that your 7 was a Z, which means Hyd. Power Supply w/ 17 g.p.m. pump. I'll look tomorrow and post it here.Also, the ser.# says your 504 is a 1966 if it's an IH (utility) or a 1967 if it's a Farmall.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|