Re: JB Weld, did it work?

Posted by dlp on February 26, 2004 at 17:44:47 from (130.184.114.79):

In Reply to: JB Weld, did it work? posted by Gary on February 26, 2004 at 09:01:01:

The trick with JB Weld is to heat the metal up slightly. When you apply the JB, it will flow like water. This helps to really penetrate the pitted area & make it adhere better. I used this trick on my Model L sleeves where it was pitted in the area of the rubber seal. Let it set, sanded it down, good as new! I have never tried it in a cylinder, but I bet it would work fine.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: JB Weld, did it work? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]