Re: Cost to Replace Clutch in 504

Posted by Randy in NE on February 23, 2004 at 12:30:44 from (216.58.237.20):

In Reply to: Cost to Replace Clutch in 504 posted by carl on February 23, 2004 at 12:13:35:

You would want to be a "good" weekend mechanic. The rear half is not much of a problem. Just a couple of blocks and either a floor jack or a bottle jack. The front half gets a little more complicated. With a wide front end you can put blocks on either side of the front end to keep it from tilting from side to side. Then you need to jack up the back of the motor. Either the front half or the back half will have to be capable of rolling. Hugh MacKay described months ago of using a pallet jack and some cribbing to roll half of the tractor around. I good splitting stand would be the best way. That will bolt to both sides of the motor and provide support for the back of the engine plus it will keep it from tilting to the left or right. If you are unsure of your capabilities you would probably be $$$ ahead to take it to a capable mechanic.

Follow Ups:

• Re: Re: Cost to Replace Clutch in 504 carl 12:56:30 02/23/04 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Cost to Replace Clutch in 504 Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]