|
Farmall & IHC Tractors Discussion Board |
Re: Re: fast hitch
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on February 18, 2004 at 19:09:48 from (64.228.11.1):
In Reply to: Re: fast hitch posted by scotc on February 18, 2004 at 17:36:37:
Scot: You do have a good suggestion as the frames of those two plows are the same. The only part different is the pull beam and it is interchangable, so he could make up a single point fast hitch pull beam for the plow without destroying the 2 point pull beam. As far as picking up plow or disk I wouldn't worry about breaking anything as Super A will not lift that much. I have a single point 6' S tine cultivator I fabricated, 18 teeth on three tool bars. I did intend building or buying a crumbler. I now have 6.5' heavy angle iron with chains on each end to pull it for leveling and crumbling. When I leave field I throw the heavy angle on top of the cultivator. I have to place this quite close to hitch point or these little tractors will not lift the cultivator. I also have a 60 gallon sprayer, with 20' boom. I fabricated the mounting so weight is as close to tractor as possible. If that sprayer is full, I have to push on hydraulic lever then lift by hand on sprayer. These tractors will lift it with my hand help. However I do have concerns re the strength of hitch linkage so I use two chains to carry weight while spraying. Super C and 200 using a remote cylinder for the hitch will lift substancially more than the Super A, 100, 130 or 140 with the touch control rockshaft. These little tractors fall down on lift quite quickly when the weight is back 3' or 4' from hitch point.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
