|
Farmall & IHC Tractors Discussion Board |
Belen power steering on M
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fred on February 16, 2004 at 17:44:45 from (65.56.195.116):
My M has a M&W live hydrolic pump on it so I hauled off and installed a powersteering motor off of an IH Cotton picker on it between the steering wheel and hood. The tractor has a 2 spool valve and a 3pt hitch. I tapped off the supply line just as it goes into the valve, and routed the discharge back into the old belly pump (used as a tank)The valve discharge goes into one side of the tank, and the power steering discharges into the other. I said all of that to say this,,,,,,No power steering. I loosened the discharge from the motor down where it goes into the tank. Only had oil when I turned the wheel. ANY ideas or suggestions would be helpful!!
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Preventing Tractor Theft - by Staff. The discussion started with the following message: I have a JD A without key start or any locking device. Is there a best way to secure it so the chances of it being stolen are reduced? Following are some of the answers that were received: Take the rotor out of the distributor and hide after each use. The would-be thieves at least couldn't just get on and drive away.
... [Read Article]
Latest Ad:
1965 International Harvester McCormick Farmall cub tractor 2,500. Two owner tractor. My grandfather bought new in 1966, then we inherited it. Have all the paperwork original manual and all maintenance records. It starts and moves. Comes with underbelly mower, plough, and some other attachments.
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|