Farmall & IHC Tractors Discussion Board |
Re: Re: Farmall 230 clutch problems
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on January 25, 2004 at 02:42:22 from (216.208.58.168):
In Reply to: Re: Farmall 230 clutch problems posted by Frank MacKay on January 24, 2004 at 19:00:16:
Frank: Welcome aboard YT discussion forums. If you go down the page a bit you will see that Paul in MI suggested I shouldn't tell you my opinion, thus forcing you to come here for advice. I went to bed early last evening, had every intention of doing as I told Paul, if you didn't respond. I even got up at 4 am here so as to get you out of bed 5 am AST. You turned the tables on me, phoned me a 1/2 hour after I went to bed. If you recall, my daughter Marilyn has a photo of you and I looking at YT some years back, right after I got involved. Everyone in the family agrees that the photo reminds them of two kids opening presents under the tree on Christmas morning. On the tractor problem I think the consences is your problem could be pilot bushing, clutch disk or presure plate. I don't think it is release bearing as it would be noisy whenever you depress clutch whether in gear or out. Unless it is as simple as fingers on presure plate out of adjustment you will have to split the tractor to find out for sure. As I said last evening there is a couple of good threads on page 3 and 4 by Dave in CT, on adjusting the fingers. As I said earlier welcome aboard, don't be afraid to ask questions on here. These guys on here are loaded with information and experiences. I will tell you there is not a more helpful group anywhere. They even start to worry about someone who hasen't been on for a few days.
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|