|
Farmall & IHC Tractors Discussion Board |
Re: Re: Re: Re: Re: New 12V coil, coil says use wi
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Doug in OR on January 21, 2004 at 13:02:31 from (159.121.94.198):
In Reply to: Re: Re: Re: Re: New 12V coil, coil says use with r posted by Paul in Mich on January 21, 2004 at 06:48:50:
It probably has an internal resistor. If you double the primary windings, you increase the inductance. In my mind, this would require a larger condensor to compensate. The real way to know if your coil is set up for 12 volts is to measure the resistance across the two studs on the coil. A 12 volt coil will have approximately 3.2 ohms. A 6 volt coil will have approximately 1.5 ohms. Yes, you need a fairly accurate ohm meter to do this. You also want to ensure that you have a good connection where your leads are contacting the studs.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Product Review: JB Weld - by Staff. JB Weld is basically an epoxy glue that does an exceptionally good job of bonding to cast iron and steel along with several other materials. As I mentioned, it is so common that I have yet to buy a tractor that did not have JB Weld used somewhere. It is sometimes used so well you can't tell its there and other times used as a sloppy quick fix. Finding where and how it can be used correctly is key to whether you are using it as an "inelegant hack" or an integral solution to difficult and expens
... [Read Article]
Latest Ad:
65 Massey FERGUSON DIESEL
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
