Re: Farmall 450 problem Clutch or torque?????

Posted by Wardner on January 21, 2004 at 08:56:08 from (67.25.171.199):

In Reply to: Farmall 450 problem Clutch or torque????? posted by Trapper Jr on January 21, 2004 at 06:28:44:

The flywheel is stepped. If you remove metal from the recessed clutch face, you also have to remove the same amount from the surface where the pressure plate attaches. At this point you need to measure the distance between both surfaces and see if it meets specifications. Unfortunately, I do not know what that number is.

I resurfaced a SMTA clutch in my lathe a few years ago. It took several cuts to get through (below) the hardened spots. I probably removed .040"-.060" on both surfaces.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Farmall 450 problem Clutch or torque????? Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]