Farmall & IHC Tractors Discussion Board |
Re: Adding a water pump to a Super A?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by F-man on January 17, 2004 at 22:19:10 from (209.41.235.79):
In Reply to: Adding a water pump to a Super A? posted by SAm in NS on January 17, 2004 at 15:12:54:
Have you ever had the head off or know that the head has ever been off? From first hand experience, I replaced a head gasket and noticed that the water jacket holes were smaller than the original. This caused the Super A to overheat. I went back to the supplier and found that there are two different head gaskets available for C-113 motors. One with small water jacket holes for motors with water pumps and one with large water jacket holes for motors without water pumps. I replaced the gasket again with the larger holes and that was the cure.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Nuts and Bolts of Fasteners - Part 2 - by Curtis Von Fange. In our previous article we discussed capscrews, bolts, and nuts along with their relative hardness and thread sizes. In this segment we will finish up on our fasteners and then work with ways to keep them from loosening up in the field. Capscrews, bolts and nuts are not the only means of holding two parts together. When dealing with thinner metals like sheet tin, a long bolt and
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|