|
Farmall & IHC Tractors Discussion Board |
Re: Purge hydraulics on C
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Randy in NE on January 07, 2004 at 08:57:34 from (65.204.94.66):
In Reply to: Purge hydraulics on C posted by Jeff in PA on January 07, 2004 at 07:59:31:
It is in the neighborhood of 3 quarts, give or take a little. You may want to replace the oil and run it a little. Then drain and re-fill it a second time. You may be able to break the lines on the inlet/outlet of the pump but you still will probably leave some old oil in there. When you fill it the hyraulic levers are supposed to be in the "back" postion. If I rememeber right you fill it to about 1/2" below the fill plug. If you do drain the oil out of the pump you may have to prime the pump by cracking a fitting on the outlet of the pump to get it to start pumping again. I guess this is why I would just change the oil twice.
Follow Ups:
Home
| Forums
Today's Featured Article -
The Day Mom Drove the 8N - by Brian Browning. My Dad was wanting to put in a garden but couldn't operate the 8N and handle the old horse drawn plow he had found and rigged up to use with the tractor. Well, he decided to go get Mom out of the house and have her drive the tractor while he walked behind the plow. You got to understand that while my Mom is a hard worker who will always help whenever she can... she had never operated farm machinery before that day. Dad got her out there, explained how the clutch was the same as in our o
... [Read Article]
Latest Ad:
18-32 Case Cross Motor
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
