Re: Clutch disc install

Posted by the tractor vet on January 06, 2004 at 20:17:27 from (216.196.13.203):

In Reply to: Clutch disc install posted by Craig Mullen on January 06, 2004 at 18:07:49:

the spring damper goes to the pressure plate side , the vary best way to put it together is hang the pressureplate and disc on the input shaft and slide it together but first lock the fingers down , this can be done buy layen your pressure plate down on the floor and using your heel push down on one lever at a time and install a 1/4 inch nut between the lever and plate . NOW most times this is done from the rebuilder and if it already done make sure that you get them out after ya start to bolt the plate to the flywheel then ya just slide the tractor together and install the bolts from underthe tractor thru the hole in the bottom this way ya only have to align the pilotbearing.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Clutch disc install Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]