|
Farmall & IHC Tractors Discussion Board |
Re: Re: 450d hyd/power steering
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Tom in Id on January 05, 2004 at 12:48:30 from (12.160.224.134):
In Reply to: Re: 450d hyd/power steering posted by Bill Evans on January 05, 2004 at 11:47:49:
Bill
I was going through old posts on this board and found this: :Posted by Jim on April 16, 2001 at 11:02:0 from (198.247.178.210) :In Reply to: Re: Re: 450 power steering posted by carl in nc on April 16, 2001 at 09:10:35: :The flow control piston and/or the bore in the hyd. presure contol valve is worn. Then the oil bypasses the steering circuit. Almost all of the used valves are also worn out. I wonder if the valve can be rebuilt good enough to get by or, does it need to be replaced? Tom
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
