Farmall & IHC Tractors Discussion Board |
Re: Farmall BN with wide front?
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by lee on January 04, 2004 at 20:21:39 from (24.24.92.235):
In Reply to: Farmall BN with wide front? posted by Irv on January 04, 2004 at 17:30:10:
The tag under the seat reads Model BN FABN 68375. That's the primary raeason I call it a Model BN. The tractor is obviously not original from the factory with the wide front. That's why I call it a BN with Wide Front. We bought it this way in the mid 80's so don't know the history. I would guess the entire front from the front of the engine forward is from an A. I went thru it in 88/89. It's been kept up and running but not seen any real work since being restored. It is not at all shoemakered up. Everything fits up well. It's a real solid machine and runs better than new. No smoke, rock steady oil pressure, real stout motor, no cracks or weld repairs. It's all Farmall. The two bull pinion drive housings in back are the same length. The left rear wheel is set away from the operator. The current wheel base in back is 72 in.
Follow Ups:
Home
| Forums
Today's Featured Article -
Ford Part Number Trivia - by Forum Participants. "Replaced by" means the part was superseded. All of my part books date back to 1964 and New Holland have changed some part numbers. They usually put the old Ford part number on the package. I was suppressed when I looked up the part number of the auxiliary drive shaft because for some reason the part number went through a radical change and it lost its "Basic Part Number". Ford part numbers follow the following rules. Most part numbers are in three parts. The middle part is called the
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|