smta ipto driven gear and shaft

Posted by paul on January 01, 2004 at 11:10:30 from (216.114.4.179):

Upon inspecting all gears and bearings in the center section I found that I could move the driven gear side to side on the shaft 1/8".Working with final drives for years I did not think that this was right.Someone had been in there before me at first I thought the bolt holding the keeper washer was to long but lock washer was tight the keeper washer was worn on the outside edge on the side that holds the gear used another 1/8 inch washer in addition to keeper washer and all side to side movement is gone.Can get about 1/32" lateral movement from shaft and now gear and shaft are tight on the spline.Any input would be a great help.Paul

Follow Ups:

• Re: smta ipto driven gear and shaft Wardner 12:22:45 01/01/04 (0)

Post A Followup Name: E-Mail: Subject: Re: smta ipto driven gear and shaft Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]