|
Farmall & IHC Tractors Discussion Board |
Re: Roll over protection for H or M---or any non R
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Rusty Jones on January 01, 2004 at 07:57:40 from (209.195.139.166):
In Reply to: Roll over protection for H or M---or any non ROP e posted by zooeyhall on December 31, 2003 at 20:26:19:
I've been reading the pro's & cons about ROPS, and what i've read so far seems to be good advice. But, like one person said, a fellow can get himself hurt or killed, right quick, by doing foolish stuff! We had a local fellow who farmed a large piece of ground, probably 150 acres, mostly flat, only a few gullies, rolling farm land. He farmed the place for quite a long time, but when a developer offered him big bucks for it, he sold, and bought a much smaller farm, rather hilly, and some woods, and a bit of open ground. Now, he always ran his tractors around with a log chain wrapped around the rear axle housing, with the hooks hanging down, inboard of the rear wheels. This didn't seem to be a problem on his old farm. But the new place, being more hilly, instantly became more dangerous to him. One day, while traversing a hillside, the dangling hook caught on the spokes of the back wheel, and when it tightened up---over it went! After several hours his wife went looking for him, and found him on his back with the tractor steering wheel crushing his chest! Didn't even have time to jump off--that quick, he was dead! So maybe ROPS would have saved him--i tend to think it would have, but then again, with the older tractors not viable for ROPS--i say, be extra careful! Happy New Year!! Rusty Jones
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Torque Wrenches - by Curtis Von Fange. When working with fasteners a torque wrench can play an important role in the correct assembly of critical equipment components. Lets examine in detail some of the reasons for using a torque wrench along with how to correctly use the variety of wrenches available. Applying the proper torque to a fastener accomplishes a number of tasks. First of all correct torque will hold the parts together. This may seem like a trite statement but � think about it for a second. Engineers have designed
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|