Re: Knock in F-30 engine

Posted by Ralph Thgmason on December 31, 2003 at 22:16:27 from (166.102.26.27):

In Reply to: Knock in F-30 engine posted by okla/kans Bill on December 28, 2003 at 11:46:06:

Bill,
I will give it a another try .If you change rod and piston,just use your rod bearing and shims if you don't want to tackle shimming the bearing.I have another question ,since your noise is constant when you pull wires.Could your governor be the culprit ? I had a F-20 that the governor weights were bad.I would advise taking a piece of rubber or plastic pipe and hold to your ear and move around over the motor when it's knocking and see if you can determine the site of knock.I have unhide my e-mail if you want to write me.Thanks Ralph ps I'm not too brillant at this time of night

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Knock in F-30 engine Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]