|
Farmall & IHC Tractors Discussion Board |
Re: hard starting 756 diesel
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by cb ont ca on December 23, 2003 at 13:44:49 from (216.209.168.169):
In Reply to: hard starting 756 diesel posted by corey Lichty on December 20, 2003 at 22:14:54:
These 6 cylinder germen engines are hard to Fire up if you don't use the primer on the fuel pump when turnimg it over cold. Shut the trouttle right down to low idle and pull the shutoff cable 3/4 of the way out till it just touches the little spring loaded plunger on side of the injection pump.Then start cranking it over, As soon as she fires let go of the shut off cable and give her a little trouttle. This works evertime on our 756 or 826 that have german diesels in them. If you look at a model 574 thru 684 with 4 cylinder germans diesels they use the same setup only its clearly marked out on there diesel shutoff control. I know since we also have a IH 684. Good luck and have a Great Christmas and New Years, Chris
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Two-Brush Generators - by Chris Pratt. Whether for product liability or because the aftermarket parts and labor business is lucrative, this concept is disturbingly prevalent. Fortunately when you step into your shop and make that jump 50 years back in time to work with your old tractor, this concept goes out the window. Even so, when it comes to the charging system, people quickly revert to this idea and start replacing the major components one at a time until it works. The reason you don't find any decals in your replacement set wit
... [Read Article]
Latest Ad:
WANTED IH C200 gas engine — complete running motor Wanted complete used IH C200 gas engine in running condition for an International 574 gas tractor. My block has a hole in it and is dead, so a rebuild kit wont do it — need a whole running motor. The C200 also came in the 544 and 674 gas trac
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|