Farmall & IHC Tractors Discussion Board |
Re: Hone Farmall H without installing new rings, p
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Fred Milner on December 16, 2003 at 17:24:48 from (66.168.91.91):
In Reply to: Hone Farmall H without installing new rings, probl posted by aaron on December 16, 2003 at 17:06:40:
I bought an H that was stuck very cheap a few months ago. I had to take the oil pan and head off to get it to turn but didn't know anything about the tractor so was unsure if it had other problems. When I got it moving I honed the cylinders with the pistons still in it just to clean them out a little. I thought I would see what it would need before I spent a lot of money on it. Got it back together and started it. Smoked like a freight train for about 10 minutes and has not smoked or used any oil since. It runs as good as any tractor I have seen so I suppose it will be good to go the way it is. We took it for a ride that was over 30 miles this summer and it never missed a lick. I got lucky this time you may also. Good luck.
Follow Ups:
Home
| Forums
Today's Featured Article -
Memories of an IH Super A When I was ? up to 10, I worked on my Papaw's farm in Greeneville, TN every summer. As I grew older (7), it was the thrill of my day to ride or drive on the tractor. My Papaw had a 1954 IH Super A that he bought to replace a Cub. My Papaw raised "baccer" (tobacco) and corn with the Super A, but the fondest memory was of the sawmill. He owned a small sawmill for sawing "baccer" sticks. The Super A was the powerplant. When I was old enough (7 or 8), I would get up early and be dressed to
... [Read Article]
Latest Ad:
Sell 1958 Hi-Altitude Massey Fergerson tractor, original condition. three point hitch pto engine, Runs well, photos available upon request
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|