|
Farmall & IHC Tractors Discussion Board |
Re: Front-wheel drive
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by texas jack on December 08, 2003 at 11:39:23 from (65.161.101.40):
In Reply to: Front-wheel drive posted by Chad on December 08, 2003 at 11:16:42:
Hello,
You are right that elwood was a common front
end on these tractors, but coleman had an
mfd that was available as well. The Coleman
seems to be obsolete.
The Elwood was a better more nimble unit but
the splines on the shafts and any moving
piece was notorious for wearing out and
failing. Salvage yards may have the parts
needed to rebuild them but since the
numbers were very limited and it has been 25
years parts would be tough to find and show
much wear when you could get them. I have
thought often of doing what you propose, but
just haven't because of the trouble it would
take to assemble everything and get the
tractor operational. I hope you do it, it should
be fun to watch.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Measuring with Calipers - by Staff. The legs of inside calipers are curved outward at the extremities to facilitate measuring small holes, while outside caliper legs have a large curve inward to increase their capacity for large work. Firm-joint calipers are adjusted approximately by the hands and then set to the feel of the work by tapping them on a metal surface. It is a common practice when opening calipers by this means to tap the top of the joint. It is better, if possible, to tap the inside of the legs, as repeated blo
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
