|
Farmall & IHC Tractors Discussion Board |
Re: 300 utility questions.
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Hugh MacKay on December 04, 2003 at 13:55:01 from (64.228.11.143):
In Reply to: 300 utility questions. posted by Bill B on December 04, 2003 at 13:27:35:
Bill: I am not very familiar with the Utility, it is quite easy to follow plumbing on the Farmall. I suspect not impossible on the Utility. Trial and error will work if you keep tractor at low idle and feather hydraulic lever lightly. Another problem I have seen is variations in plumbing even within models. On weight it will be a bit heavier than H, but loader and rear blade are big difference. I had hauled numerous 275, 444, etc on my 3/4 ton Chevy and 16' car hauler. One day I passed a friend on road with his 444 loader, two buckets and a 3point logging winch. I knew he was heading 15 miles to his wood lot, and it was about -10F. I stopped and told him anyone close to our age (60) should have enough money, he shouldn't need to drive tractor in that cold air. I suggested he load it on, he did, and man was I ever glad when that was over. I got home and discovered I had some cracks in trailer frame.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Tractor Profile: Case VA Series - by Staff. V, VC, VI and VO). Althouh the Case VA looked much like the V, it shared no major components with its predecessor. Except for military units, the production of the Case VA was interrupted in July of 1942 due to World War II. It resumed again in 1944 and continued until 1953. It started up briefly later on in 1953 and continued on a very limited basis until 1956. The VA Series included the following models: VA: Fixed front wheel tread VAC:
... [Read Article]
Latest Ad:
Massey Ferguson model 65 diesel tractor
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
