Re: F20N Update/Questions

Posted by Bill B on November 29, 2003 at 15:50:26 from (68.118.185.80):

In Reply to: F20N Update/Questions posted by Tony on November 29, 2003 at 08:45:35:

This may not be relevent in this case, but I feel the need to caution you on the set screw. Many years ago I was working in a stamping plant and had to remove a flywheel from a press. I loosened the set screw and started to remove the big nut when it bound up. I found that there were two set screws in the same hole, and the one I loosened was only a lock screw against the lower one that was doing the job. I had to remove the set screw entirely to get at the one below it, and also removed that one entirely. I buggered up the threads a bit, but it came off. I always check now, by removing the set screw entirely and looking inside.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: F20N Update/Questions Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]