|
Farmall & IHC Tractors Discussion Board |
Re: Going to attempt clutch job on 400
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by Yoda the tractor spliter on November 28, 2003 at 15:41:58 from (64.136.26.225):
In Reply to: Going to attempt clutch job on 400 posted by Kelly C on November 28, 2003 at 05:53:48:
Kelly
When you split a tractor with a rowcrop front end a fool proof way of doing it safely is to use 4 24" guide pins in place of the frame to clutch housing bolts, two per side. This prevents the front from rolling over on you and assists with aligning it up when going back together. If you have 2 floor jacks use one under the rear end and one under the front for extra safety. With this method a clutch job is 2 hours max. Id rather split one than do a carb rebiuld. Good luck my young padwan learner.
Follow Ups:
Home
| Forums
| Order Support
Today's Featured Article -
Case Farm Equipment - by Jeremy Sweeten. My name is Jeremy Sweeten and I am currently a junior at Purdue University. I am takin a dual major in Agriculture Systems Management and Agronomy. I am from North Central Indiana, Miami County to be exact. My dad teaches for Marion Community School Systems an outdoor lab called Asherwood. We live there to manage the place. They just happen to have a Case 311 with a Triple Range transmission. I grew up mowing, pushing snow, and hauling maple sap with it. In 1986 my parents bought an old,
... [Read Article]
Latest Ad:
Late 50s early 60s international harvester 560 with cultivator
[More Ads]
Copyright © 1997-2026 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
