Farmall & IHC Tractors Discussion Board |
Re: Lift all system in a H
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by 26Red on November 26, 2003 at 14:06:43 from (170.92.1.104):
In Reply to: Lift all system in a H posted by Tim Mc on November 26, 2003 at 11:24:45:
The lift-all system is a one-way hydraulic setup. The 3 ports are all output ports, there is no need for return ports. The 3rd one closest to the rear of the tractor has delayed lift feature. This was used when a cultivator was mounted in front and on the back of the tractor. When you got to the end of the row, the front cultivators would raise first, then the rear. See www.farmall-h.com for a better explaination. If you want double-acting hydraulics, you can plumb a hydraulic spool valve(3-way controls- up, down, and hold) into one of the lift-all output ports. Then run a return line to the lift-all tank's drain plug to complete the setup.
Follow Ups:
Home
| Forums
Today's Featured Article -
George's Fordson Major - by Anthony West (UK). This is a bit of a technical info to add on to the article about George's Major in the "A Towny Goes Plowing" article. George bought his Major from a an implement sale about 18 years ago for £200.00. There is no known history regarding its origins or what service it had done, but the following work was undertaken by Harold alone to bring it up to show standard. From the engine number, it was found that the major was produced late 19
... [Read Article]
Latest Ad:
Oliver 550 Diesel runs like a watch three point hitch pto engine gone threw about two hundred hours ago nice clean tractor
[More Ads]
Copyright © 1997-2024 Yesterday's Tractor Co. All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|