|
Farmall & IHC Tractors Discussion Board |
H Transmission Lift-All drive dog and shaft sti
[ Expand ] [ View Follow Ups ] [ Post Followup ] [ Return to Forum ]
Posted by John on November 24, 2003 at 18:25:16 from (192.233.162.158):
I posted about my problem a few months ago on my H, my problem still didn't solve its self like I was hoping for. I changed the seal on the Lift-All drive dog on the transmission side. I put itback together with the drive dog on the transmission shaft finger tight (Got the drive shaft kind of snug). My problem is that the shaft loosens up a little when first started, the Lift-All drive shaft is a little loose, not falling out shaking loose, but looser than before I changed the seal. I had hoped using the Lift-All with a hydraulic cylinder would cause the drive dog to self tighten against the drive shaft making it kind of tight. I am stumped, any ideas out there? My Lift-All drive shaft was kind of tight before I changed the seal ,I don't think my parts are worn out. Thanks!!!
Follow Ups:
Home
| Forums
Today's Featured Article -
Tractor Traction - by Chris Pratt. Our first bout with traction problems came when cultivatin with our Massey-Harris Pony. Up till then, this tractor had been running a corn grinder and pulling a trailer. It had new unfilled rear tires and no wheel weights. The garden was already sprouting when we hooked up the mid-mount shovel cultivators to the Pony. The seed bed was soft enough that the rear end would spin and slowly work its way to the downhill side of the gardens slight incline. From this, we learned our lesson sinc
... [Read Article]
Latest Ad:
1964 I-H 140 tractor with cultivators and sidedresser. Starts and runs good. Asking 2650. CALL RON AT 502-319-1952
[More Ads]
Copyright © 1997-2025 Yesterday's Tractor Co.
All Rights Reserved. Reproduction of any part of this website, including design and content, without written permission is strictly prohibited. Trade Marks and Trade Names contained and used in this Website are those of others, and are used in this Website in a descriptive sense to refer to the products of others. Use of this Web site constitutes acceptance of our User Agreement and Privacy Policy TRADEMARK DISCLAIMER: Tradenames and Trademarks referred to within Yesterday's Tractor Co. products and within the Yesterday's Tractor Co. websites are the property of their respective trademark holders. None of these trademark holders are affiliated with Yesterday's Tractor Co., our products, or our website nor are we sponsored by them. John Deere and its logos are the registered trademarks of the John Deere Corporation. Agco, Agco Allis, White, Massey Ferguson and their logos are the registered trademarks of AGCO Corporation. Case, Case-IH, Farmall, International Harvester, New Holland and their logos are registered trademarks of CNH Global N.V. Yesterday's Tractors - Antique Tractor HeadquartersWebsite Accessibility Policy |
|
