Re: Super H starter binding

Posted by Steve - IN on November 07, 2003 at 18:46:48 from (12.222.30.13):

In Reply to: Super H starter binding posted by Eric NW Iowa on November 07, 2003 at 10:33:07:

Eric,
Just like you and everybody else, I've had that same problem with my H -- pull the starter to get it free when it locked up.

Last time I pulled the starter, I tore it down - cleaned and lubed the Bendix gears and the bushings, replaced the brushes at a buck or two each. Then I stuck 00 gauge welding cable on it from batt to switch, switch to starter, and batt ground to ground on stater mount bolt, plus put in a killer Optima 6V battery.

So far (a year or so later), I'm amazed. Sounds like it's turning over super fast -- at least as fast as the 12V on the JD lawn tractor with the Kawasaki engine. Of course, if your problem is in the ring gear like Bob says, the results are going to vary. What's more, if I were to run 30W or 40W oil in it and try it this winter -- I doubt I'd get that fast turnover. So consider that as well -- and good luck in cheaply finding the major cause of the problem.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Super H starter binding Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]