Re: Re: Re: h hydralic question

Posted by 26Red on October 28, 2003 at 10:51:15 from (170.92.1.104):

In Reply to: Re: Re: h hydralic question posted by Greg on October 28, 2003 at 10:38:03:

You can switch your setup to a two way hydraulics by adding 3 position hydrualic control valve. Just plumb the inlet(pressure)of the valve to the output port of the liftall pump. Then run the return line into the drain plug of the lift-all pump(located underneath the tractor). Tricky part is mounting your control valve in a handy spot. Obviously to operate the system, you will have leave the lift-all pump on all the time. Or just turn it on when you need to lower or lift the disk.

Follow Ups:

Post A Followup Name: E-Mail: Subject: Re: Re: Re: Re: h hydralic question Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]