Re: Re: WD6 starter

Posted by Steve - IN on October 24, 2003 at 13:30:37 from (12.222.30.13):

In Reply to: Re: WD6 starter posted by Fred on October 24, 2003 at 06:48:54:

Fred,
Hard to tell with the spring unless you know somebody who can test spring rates and knows the spec. On my H (which is the same as a W4, not 6, but similar anyway) I disassembled the whole Bendix gear, cleaned all the built up crud off, and lubed it -- made the whole thing slide in and out a whole lot easier. I also relubed the bearings and changed the brushes. Made the thing turn a lot faster as well. If you haven't already, might try that as it's a whole lot cheaper than biting the bullet on a new Bendix assembly. Good luck with it.

Follow Ups:

• Re: Re: Re: WD6 starter Tks Steve 14:20:24 10/24/03 (0)

Post A Followup Name: E-Mail: Subject: Re: Re: Re: WD6 starter Comments: Optional Link URL: Link Title: Optional Image URL: Email Notification: If you check this box, email will be sent to you whenever someone replies to this message. Your email address must be entered above to receive notification. This notification will be cancelled automatically after 2 weeks.

TRACTOR PARTS	TRACTOR MANUALS

We sell tractor parts!  We have the parts you need to repair your tractor - the right parts. Our low prices and years of research make us your best choice when you need parts. Shop Online Today. [ About Us ]